Post by Oliver Machinery on Jan 28, 2013 9:01:54 GMT -8
Error Codes
• LIMIT SWITCH ERROR (Error 1):
Causes: X, Y, or Z axis over travels and hits limit switch or its wire is disconnected.
Solution: Turn off the power and restart the machine. Then, the axes should function.
• SPINDLE MOTOR OVERHEAT (Error 12):
Causes: Spindle motor shuts down automatically when overheating.
Solution: Turn off the power. Then restart the power after 5 minutes.
• ELECTRICAL ERROR 13 (Error 13):
Causes: Spindle motor shuts down automatically when disturbances from other sources occurred.
Solution: Ensure power supply is earth grounded. Avoid sharing same loop with other equipment.
• ELECTRICAL ERROR 21 (Error 21):
Causes: Wire disconnection between HMI (Human-Machine Interface, refer to the screen and buttons) and PCB (Printed Circuit Board).
Solution: Turn off the power and ensure wires are well connected among PCB, HMI and LCD. Restart the machine and it should function.
USB ERROR (Error 23):
Causes: Misconnected USB or defective USB.
Solution: Unplug the USB and restart the machine. Re-plug in the USB. Or replace the USB.
• ELECTRICAL ERROR 24 (Error 24):
Causes: HMI cannot detect PCB connection.
Solution: Turn off the power and ensure wires are well connected among PCB, HMI and LCD. Restart the machine and it should function.
• ELECTRICAL ERROR 26 (Error 26):
Causes: PCB cannot detect HMI connection.
Solution: Turn off the power and ensure wires are well connected among PCB, HMI and LCD. Restart the machine and it should function.
• LIMIT SWITCH ERROR (Error 1):
Causes: X, Y, or Z axis over travels and hits limit switch or its wire is disconnected.
Solution: Turn off the power and restart the machine. Then, the axes should function.
• SPINDLE MOTOR OVERHEAT (Error 12):
Causes: Spindle motor shuts down automatically when overheating.
Solution: Turn off the power. Then restart the power after 5 minutes.
• ELECTRICAL ERROR 13 (Error 13):
Causes: Spindle motor shuts down automatically when disturbances from other sources occurred.
Solution: Ensure power supply is earth grounded. Avoid sharing same loop with other equipment.
• ELECTRICAL ERROR 21 (Error 21):
Causes: Wire disconnection between HMI (Human-Machine Interface, refer to the screen and buttons) and PCB (Printed Circuit Board).
Solution: Turn off the power and ensure wires are well connected among PCB, HMI and LCD. Restart the machine and it should function.
USB ERROR (Error 23):
Causes: Misconnected USB or defective USB.
Solution: Unplug the USB and restart the machine. Re-plug in the USB. Or replace the USB.
• ELECTRICAL ERROR 24 (Error 24):
Causes: HMI cannot detect PCB connection.
Solution: Turn off the power and ensure wires are well connected among PCB, HMI and LCD. Restart the machine and it should function.
• ELECTRICAL ERROR 26 (Error 26):
Causes: PCB cannot detect HMI connection.
Solution: Turn off the power and ensure wires are well connected among PCB, HMI and LCD. Restart the machine and it should function.