|
|
Post by stanhowe on Nov 10, 2017 8:55:00 GMT -8
anyone have difficulty with the depth of cut drifting from set point, if so what is the fix?
|
|
|
|
Post by stanhowe on Nov 11, 2017 10:50:04 GMT -8
I bought it anyway, Appears to be co-planner now based upon test cut i did on a long board. The way the previous owner explains it, if you make an adjustment to the depth of cut the infeed table goes out of coplanar alignment.
|
|
|
|
Post by stanhowe on Nov 13, 2017 14:36:21 GMT -8
so I spent a couple hours yesterday tuning the machine, it was simply out of co-planner alignment by about .040 on the outfield, and the cutter head was out of parallel with the indeed by about .004" and it looked like it had never been adjusted (paint still on the lock nuts of the gib screws) now it is perfect and i verified with a straight edge it stays perfect at least down to about 1/4", i didn't feel the need to check it any further.
|
|
