Post by Michael on Feb 1, 2015 19:54:34 GMT -8
To prevent concave stock on the end it appears to be necessary to raise the outfeed table about 1/32 inch above the highest level of the infeed table.
The infeed and outfeed tables do appear to be level. That has yet to be tested with a reasonably good straightedge that is yet to be acquired.
If the two tables are level, but both tables are below the highest point on the cutter head how can the cutter head be adjusted lower?
The infeed and outfeed tables do appear to be level. That has yet to be tested with a reasonably good straightedge that is yet to be acquired.
If the two tables are level, but both tables are below the highest point on the cutter head how can the cutter head be adjusted lower?