|
|
Post by gregory on Aug 4, 2015 17:34:41 GMT -8
Should these carvers have a power supply to solve some of the power surge glitches, I know about having it's own circuit, but has anyone put a power supply between the plug and the machine, so the power going into the machine isn't interrupted?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 5, 2015 6:56:59 GMT -8
Gregory: Usually ANY power interrupt will shut your machine down and it does not take much (a matter of milli-seconds). The power continuation devices I have seen still have a lag time in milli-seconds before they engage, so I don't think that would solve any thing. Even if to just assure constant voltage flow, they still have a lag time to engage and they are rather expensive. If your machine is not shutting down in the middle of a project I would doubt you have a power problem.
|
|
