Deleted
Deleted Member
Posts: 0
|
Runout
Mar 31, 2013 14:19:30 GMT -8
Post by Deleted on Mar 31, 2013 14:19:30 GMT -8
Wow, I was just doing a carve with 1/8" end mill to clear off a test carve I did on a board so it could be used for another project, set it to carve 3mm deep to clear the board went back to the shop to check on it and the machine was stopped. The carve went at an angle( about 5 degrees ) on the board until the angle led to the x limit switch and shut it down. Any clues as to why this would happen?
|
|
|
Runout
Jan 18, 2016 15:46:41 GMT -8
Post by mroliver on Jan 18, 2016 15:46:41 GMT -8
Wow, I was just doing a carve with 1/8" end mill to clear off a test carve I did on a board so it could be used for another project, set it to carve 3mm deep to clear the board went back to the shop to check on it and the machine was stopped. The carve went at an angle( about 5 degrees ) on the board until the angle led to the x limit switch and shut it down. Any clues as to why this would happen? TRY CARVING ON SLOW AND ALSO TRY CLEANING IT
|
|